Profitieren Sie von unseren Schul-/Behörden Rabatten
Carrier board for step motor driver DRV8880 from TI six step resolutions adjustable current control

Item number: PO-2971

This breakout board for TI's DRV8880 bipolar stepper motor driver features adjustable current limiting, overcurrent and overtemperature protection, and six microstep resolutions (up to 1/16 steps).

Category: Single Motorcontroller


9,22 €

including 16% VAT. , plus shipping (Standard)

availability on request (delivery time usually 5-10 working days)


This product is a carrier board or breakout board for TI's DRV8880 stepper motor driver. With this stepper motor driver you can control a bipolar stepper motor with up to 1.6 A output current per coil. Here are some of the most important features of the driver: Simple step and direction control interface Six different step resolutions: Full step, half step, non-circular half step, 1/4 step, 1/8 step and 1/16 step. The adjustable current control allows you to set the maximum output current with a potentiometer that allows you to use voltages above the rated voltage of your stepper motor to achieve higher step frequencies. Digital inputs to dynamically scale the current limitation to 25%, 50%, 75% or 100% of the limit set by the potentiometer, allowing you to reduce power consumption in situations where no full speed or torque is required. Ten Different Decay Mode Options 6.5 V to 45 V Supply voltage range Integrated controller (no external logic power supply required) Can be directly connected to 3.3 V and 5 V systems. Thermal overtemperature cut-off, overcurrent cut-off, short-circuit protection and undervoltage cut-off. 4-layer, 2 oz copper board for improved heat dissipation Exposed solderable ground pad below the driver IC on the underside of the PCB Module size, pin assignment and interface correspond in many ways to those of our A4988 stepper motor driver carriers. Hardware Included The DRV8880 stepper motor driver carrier is supplied with a 1×18-pin, detachable 0.1" male connector. The pin strips can be soldered in for use with solderless punched grid cards or 0.1" socket strips. You can also solder your motor cables and other connections directly to the board. Translated with www.DeepL.com/Translator

Shipping weight: 0,01 Kg
Contact